Support Center

Recording a New Outgoing Message on the ANS3000

Last Updated: Jun 23, 2017 03:16PM CDT
To record a personalized outgoing message on your ANS300:
  1. Press and hold either the OGM1 or OGM2 button until you hear "to record your message, please speak after the tone.  When you are finished, press Stop." Take your finger off the button and begin speaking after you hear the tone.  
  2. Press Stop when you have finished your recording or the ANS3000 will continue to record 3 minutes of room noise.  
  3. The ANS3000 will then play back the message you have recorded so that you can review it.  The message is then saved automatically. 
  4. If you do not like the way the message sounds, follow steps 1-3 again to re-record the message.

Contact Us
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found